Instructions de montage pour les puces TCR (No Solder) V5/V6/V7.

(1) Please prepare a screwdriver and a tweezers (for the flat ribbon cable).

(2) Unplug the power of your PS2 console.
Turn over the PS so you can see that 8 plastic covers as shown in the picture.

 

(3) Remove the 8 covers and unscrew the eight screws.

(4) If there is a sticker on your consoles, remove it as shown below.

(5) Remove the upper part of the PS2 case now.

(6) Remove the power and eject buttons as shown in the following illustration:

(7) Remove the screws as shown below to remove the lower casing of the PS2 console:

(8) At the left side, near the CD tray, there are 3 flat ribbon cables, as shown in the first of the two following pictures.
Unplug the left and the middle one of the three cables.
 

 


 

(9) Connect the two flat cables to the PS2 R-Mod Board exactly as shown here:


(10) Now connect the PS2 R-Mod to the two connectors where you previously removed the two flat cables.

(11) Now Re-assemble the PS2. There was No soldering required.